Here is a card project that mixes an analagous color scheme with neutrals. An analagous color scheme is one that uses colors that are near each other on the color wheel, in this case blue, blue-green and blue-purple. The colors are so close together that it’s nearly a monochromatic color scheme – a design that uses tints and shades of one color. My samples were made as birthday cards, but you can make the card for multiple occasions by changing the sentiment stamp. This card helps you to use up paper scraps!
Tools and Supplies
Rubber Stamping Ink
Waterproof ink in light to medium neutral colors
Pigment or chalk ink in white or very light blue
Dye inks in various shades of blue
Dye ink in black
Clean scrap paper
Freezer paper or temporary palette
Flat sided white eraser like a Magic Rub
Paper scraps in neutral shades and blue shades
Circle punch that is a good size for the center of the flower
Thin navy blue marker
1. Take an 8.5 x 5.5″ piece of cream colored cardstock, score down the middle and fold in half.
2. Using some of your favorite background stamps, stamp in light to medium neutral waterproof ink colors in the four quadrants of the front of the card. Make the axis about three inches up from the bottom of the card so that the lower quadrants are taller than the upper quadrants.
3. Place your folded card face up on some clean scrap paper. With your brayer roll out some very light blue chalk or pigment ink onto a palette or temporary palette made of freezer paper. I only had white ink so I tinted mine slightly with some blue dye ink. Roll the ink over the front of the card several times until designs on the front of the card are subdued by a light blue semi-transparent tint.
If you don’t have a brayer or suitable pigment ink you can make a wash out of acrylic paint or gesso and brush that over the stamped images.
4. Let the ink dry. Most pigment and chalk inks dry slowly so if you have to speed up heating use a heat tool or hair dryer. Heat tools are hotter than hair dryers so use caution. To test whether your ink is completely dry, place a piece of clean scrap paper over it and rub with a bone folder. Lift up the scrap paper. If no ink comes off, it’s dry.
5. Cut out an assortment of 1.75″ x 1.75″ squares of medium neutral shades and different light to medium blues. Stamp backgrounds with an assortment of neutral inks and inks in shades of blue. Leave a few blank. Make more than you think you will need so you can mix and match later on to get combinations that please you.
6. Outline the squares in blue ink by squirting a bit of ink onto an old lid and dipping the edge of your eraser in it. Use the eraser to transfer the ink to the edges of the squares. In the image below, the stamp at the lower left is by Inkadinkado and the stamp at the lower right is by Stampington.
7. Assemble a collection of paper scraps in neutral shades and shades of blue. You can use both plain and patterned paper. Punch out a bunch of flower shapes and circles for the insides of the flowers out of these scraps. Make more than you think you will need so you can mix and match to find good combinations as you’re assembling the cards.
8. Take some of the solid color center dots and stamp on them in neutral or blue inks.
9. Take some of the solid color flower shapes and stamp on them in shades of blue.
10. Lay four squares down on the front of your card and select four flowers and centers that you like to place within the squares. You can mix and match solid and printed colors if you like. A solid piece here and there gives the design a little breathing room.
11. Draw “stitches” with a navy blue marker around the inside edges of the four squares. Do the same with the insides of the circles.
12. Glue the circles to the flowers, then the flowers to the squares. Glue the squares down in the upper 3.75″ area of the card. Place a piece of clean scrap paper over all and burnish with your bone folder so the glue has a nice tight seal.
13. Cut out a .75 x 4.25″ strip of cream colored card stock. Stamp a sentiment in black ink on it. The Happy Birthday stamp I used in my samples is from Carolyn’s Stamp Store. Apply blue ink to the edges with your eraser. After the ink is dry, glue the strip to the front of the card and burnish well. Trim if needed. You’re done!
Optional embellishments: Sew small buttons in the flower centers or add a decorative flower blue eyelet or brad to each flower center. If you decide to sew on buttons, you may want to sew the stitch marks in step 11 instead of drawing them on.