Tag Archives: Dia de los Muertos

Make a Soft Dia De Los Muertos Skull

Soft Dia De Los Muertos Skull made using discharge paste, embroidery, fabric paint, and embellishments
Soft Dia De Los Muertos Skull made using discharge paste, embroidery, fabric paint, and embellishments

Do you want to have some fun with a mixed-media fabric project? This soft Dia De Los Muertos skull uses discharge paste, fabric paint, embroidery and embellishments – you can use a lot of your toys for this one! Enhance your decor with a small decorative throw pillow or attach a loop to the back and hang it on the wall.

This tutorial assumes you know the basics of cutting stencils and stenciling on fabric. If you need more of an introduction to those skills, see my tutorial “Fun With Stencils”. You’ll need a few very basic sewing and embroidery skills too.

Read more at the Jacquard Products web site

Lots of new projects

I’ve been keeping busy with lots of new work – here are some samples of some projects in progress!

06-09-14 – Here is what is on my work table –
Using some of the stencil/embroidery fabric experiments to applique onto
the front of a wine bag to upcycle it. One piece is for the front and
one for the back. I’m sewing fabric pieces and ribbon onto pieces of
fusible webbing then will sew around the edges to attach to the pieces
to the front and back of the bag.

06-18-14 – On my work table today – greeting
cards right before all the parts are glued together. Techniques used –
collage, rubber stamping, stenciling. Some of the stencils are
commercial and some are designed and cut by me. Commercial stencils available here – http://carolynsstampstore.com/catalog/stencils-stenciling-supplies-c-45.html

06-22-14 – On my work table today – I cut
these stencils for a Day of the Dead project. Going to experiment with
some discharge paste on fabric.

06-23-014 – Plant trays in progress – doing a
little work on my deck this morning. On Saturday my Dad cut up some
recycled wood for me to make these trays and yesterday I nailed them
together and put wood filler in the cracks. This morning I
sanded them and lined the insides with roof cement. My intention is to
display plants in these at shows and fill in with black gravel to make a
nice uniform appearance. The roof cement is meant to make a waterproof
seal so I can water the plants and not have to worry about damaging
surfaces or putting little saucers under each one which takes up a lot
of room on the table. I want to put folding legs on these trays to
display the plants below table level in front of the tables and I’m
still working out the best way to do that. I was looking in the outdoor
storage closet for some wood pieces I might be able to use for the legs
and saw some folding chairs that came with the condo. In a pinch I could
set the larger tray on two of the chairs until I figure out the legs –
but that gave me another idea – what if I just made two sets each of
smaller and narrower folding legs without seat covers? That would work I
think. Could I put some kind of channel on the bottom to hold the legs
in place and let gravity do the rest? Then it would all fold down for
transport. These trays gave me another idea – what if I made these
without a wide rim but just enough to be level with a ceramic tile
mosaic and designed them to drain instead of hold water? Would make good
garden/patio accessories I think.